FAAC Gate Motor & Opener Nationwide

FAAC Gate Motor & Opener in Plano: What to Know First

We repair and install FAAC gate motors and openers across Plano, typically completing most motor repairs the same day we diagnose them. Most FAAC gate motor repairs in Plano run between $240 and $680, and that price is written and handed to you before any work starts, not after. If your FAAC gate is dead, grinding, or reversing for no reason, call (972) 236-7089 and a live person answers, any hour.

Call (972) 236-7089

This page is for Plano homeowners who researched the problem, know their gate runs a FAAC motor, and want the real failure patterns, the actual cost ranges, and a company that documents everything it finds. We’re an independent FAAC service provider. We are not affiliated with or authorized by FAAC, which means we fix what’s actually wrong rather than steering you toward a replacement you don’t need.

How FAAC Products Fail — and How We Fix Them

• FAAC 400 Series (swing gates): the capacitor dies quietly. In Plano’s summer heat, the motor run capacitor on the 400 and 402 operators degrades faster than the motor itself. The symptom is a gate that hums but won’t move, or moves half-speed on hot afternoons and fine in the morning. We test capacitance under load, not just with a meter across the leads. The fix is a $45–$90 part, not a $900 motor replacement, and we photograph the test reading for your record.
• FAAC S800H (slide gates): the limit-switch logic drifts with temperature swings. North Texas gets 40-degree swings in a single day, and the magnetic limit sensors on hydraulic slide operators shift their trip points as the rail expands. The gate starts stopping six inches short or slamming the stop block. We reset the limit positions, verify the encoder count, and record the exact setting so the next adjustment doesn’t start from zero.
• FAAC 844 ER (slide gates): board damage from power surges, not lightning. Most owners assume a storm killed the board. What we actually find on the 844 ER in Plano neighborhoods with older transformers is brownout damage: low voltage builds heat in the rectifier circuit until a capacitor swells and the board fails. The fix is a replacement control board plus a surge suppressor installed at the disconnect. We’ll show you the swollen component before we replace it.
• FAAC 750 and 391 (swing gates): the hydraulic pump runs but the ram does not move. This is almost never a pump failure. It’s either a bypass-valve O-ring that’s hardened and leaking internally, or air in the line from a slow fitting leak. A FAAC dealer may quote a full pump assembly. We rebuild the valve stack with OEM O-rings, bleed the system, and pressure-test before we call it done. Typical repair is under $300.
• FAAC E024U control board: phantom reversals at dusk. This one catches people off guard. The photo-eye circuit on the E024U picks up interference from low-quality LED landscape lighting installed near the gate. The gate starts closing, then reverses like something’s in the way. The fix is a shielded cable run for the photo-eye and a ferrite choke on the lighting circuit, not a new board and not a new motor.

Our FAAC Gate Motor & Opener Process

1. 1
   Call, answer, dispatch. You call (972) 236-7089. A live person answers. We schedule a window that works, and you get the technician’s name and photo before they arrive.
2. 2
   On-site diagnosis with documentation. We meter the incoming power, test the capacitor and transformer, check the limit settings, and inspect the gearbox or hydraulic ram. We photograph every test reading, including the fault code on the control board if one’s present.
3. 3
   Written price before any tool comes out. We hand you a flat price for the repair, in writing, with the part number and labor broken out. You approve it before we turn a screw. Haven Standard Clause 1: have it in writing.
4. 4
   Parts decision, stated plainly. If a part is available as OEM FAAC, we use OEM unless you want a quality aftermarket option that we can vouch for, and we tell you the trade-off and warranty difference on the spot. We never install a part we wouldn’t put on our own gate.
5. 5
   Repair, test under load, and adjust. We run the gate through 10 full cycles in both directions, test the obstruction reversal with a physical object (not just a hand wave), and recheck torque settings. Swing gates get a travel-time check against the manufacturer’s spec.
6. 6
   Photo log, clean site, Done Right Promise. Before we leave, you get a documented photo record of every adjustment, every part number, and the final test readings. The job site is cleaner than we found it. Every repair is covered by the 365-Day Done Right Promise: if it’s not right within a year, we make it right at no charge, no argument.

Before

After

What FAAC Gate Motor & Opener Costs in Plano

Most FAAC repairs in Plano land between $240 and $680. Here’s what that looks like by job type:

• Capacitor replacement (400/402 series): $180–$260 installed
• Limit-switch reset and encoder calibration (S800H, 844 ER): $150–$280
• Hydraulic bypass-valve rebuild (750, 391): $260–$400
• Control board replacement with surge protection (E024U, 844 ER): $380–$650
• Full FAAC swing motor replacement (parts and labor): $850–$1,400 depending on model and whether the arm bracket can be reused
• Full FAAC slide motor replacement: $900–$1,600 depending on horsepower and rail condition

What moves the price? Whether the motor is swing or slide, the specific FAAC series on your gate, whether the control board can be reused, and the condition of the mounting hardware and brackets. You get the exact number in writing before we start. Call (972) 236-7089 for a free estimate, and you’ll see the price on paper before any work begins.

Why Plano Homeowners Call Vance Gate Repair Plano for FAAC Work

Adrian Vance has been running gate repair calls across Plano since the company started in 2014, including a long stretch of swing-gate work out near Legacy West that taught us how FAAC operators behave in Texas heat. We don’t guess and we don’t upsell. We document what we found, hand you the price, fix the motor, and hand you the photo log before we leave.

Plano homeowners also call us because we service nine gate-automation brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. If your FAAC turns out to be end-of-life and you’d rather not replace the motor, we’ll tell you straight and quote a comparable LiftMaster or Ghost Controls replacement. If you have another gate on the property running a different brand, we fix both. One company, one visit, no brand steering.

And one thing we hear a lot from Plano customers who found us after another quote: they bring us the other company’s written estimate and we review it free. A free second opinion on any written estimate, from any company. If we can’t beat the price or find a reason the scope is wrong, we’ll say so.

FAQs